Th400 w/ np208 output shaft bushing

[dixiechevy01]

Well I put a new rear output shaft seal in my np208 and the seal is leaking again. I used a timken seal so I figured it was good quality but I didn't replace the bushing. The output shaft didn't look worn to bad so all I replaced was the seal. Now I'm planing on replacing the seal and bushing but can't find a bushing driver anyone have any idea where I can find one?

 

[dixiechevy01]

Anyone have any idea where to find that bushing driver?

 

[diesel4me]

Probably Greg Ducato here,he;s the tranny expert..

I've seen pictures of them in GM manuals made bt Kent-Moore,but I have no idea if they are even still around or not..did you google it to see if anything popped up?..

Maybe you could use a slip yoke with a large washer as a bushing driver...?

 

[dixiechevy01]

Well i think my problem is that my driveshaft is to short. With the 4" lift and 35" tires it pulls the slip yoke out like 2 inches