tierod replacment

[jfabert]

Well I bent the stock tierod and need a new one. ORD sells 3 of them that are stronger but does any one know what a stock on will cost and were to get a new one for comparison? It is for the stock 10 bolt. I probaly will end up ordering one from them but just wanted to look around and prove to my wife that it is a better investment. I was also looking at the rockrod also.

 

[readymix]

Here is the info for the stick setup
http://www.lmctruck.com/icatalog/cc/0127.asp

That said. I would reccomend you go aftermarket. I prefer the style that uses two short TRE's instead of the one long, one short and the adj sleve.

 

[Hogback Fabrication]

There are lots of companies that make them. I got mine from http://northwestfab.com/

 

[jfabert]

There are lots of companies that make them. I got mine from http://northwestfab.com/

what was the shipping on it aprox? Its the same size and price as ORD. Also are you running a stabalizer with it? How if so?

 

[Hogback Fabrication]

what was the shipping on it aprox? Its the same size and price as ORD. Also are you running a stabalizer with it? How if so?

I don't remember what shipping was, but it was cheaper overall than anywhere else I found and they used the same DOM tube and same brand TRE's as everyone else.

I don't run a steering stabilizer, I have hydro assist.

If you wanted to run a steering stabilizer you can either weld tabs on for the stabilizer or they make a mount that uses u-bolts to hold the stabilizer to the tie rod.