Trans/T-Case Bushings

[NV_K5]

I finally got around to installing my twin stick on my NP205, before I put it back in I need to replace the adapter bushings and the transfer case torque mount bushings.

I don't care if there poly or rubber as anything is better than what I currently have.

Yes I searched, no I didn't find it.

 

[irokgmc]

Look lower on this page, I got mine from there:
Bushings

 

[NV_K5]

Awesome - Thanks!

 

[Larry_in_Tx]

Do you have poly or rubber motor mounts? If you go poly at the tranny/t-case and have rubber motor mounts you're bell housing stands a good chance of breaking on you.

 

[NV_K5]

I have rubber motor mounts and now that I have a source for replacements, I will stick with rubber trans mounts etc because it's cheaper and allows for flex.

The motor mounts are like $8.00 and the link provided shows rubber trans mounts for $40.00 not bad.

 

[NV_K5]

The lower portion for the Trans mt from Napa was $5.29 each part no. 602-1035 2ea.
The upper portion was $6.79 each and part no. 602-1034. Both rubber and reuse the metal bushing and bolts. 2ea. Total for these from Napa $24.16

I purchased the torque mt bushings from Summit in poly. Part no. PTP-7-1603. I know your not supposed to mix the two but I think their molded better and will prevent the twisting - (like their supposed to) and last a lot longer than rubber in that spot while preventing vibrations etc.