what to do with this cam

[cEN]

to start off im not posting here to sell i'll post it in the for sale section once i figure it out.

okay so the LT1 motor i got came with a brand new cam but it is the wrong cam for my intended setup so i'm at a loss what to do, i would like to sell it, hasn't been used so no wear on the lobes, is it now a paper weight or what? opinions appreciated
thanks

 

[Deuling]

Hard to say without posting specs on it

 

[cEN]

oh whoops its a comp cam 07-468-8

 

[cEN]

heres a link to it
http://www.compcams.com/Company/CC/cam-specs/Details.aspx?csid=1112&sb=0

 

[sweetk30]

these guys would prob buy it faster than here . http://www.thirdgen.org/techboard/

can be used in sbc with 1 peice rear main if block has bosses in lifter area for spider to hold lifters inplace as a roller cam upgrade. just have to shave a tiny bit off the front dowl pin to fit .

and roller cams can be swaped around much easyer than flat tappet . as long as lobes dont show wear on them . and even if rollers on lifters are clean good wear can reuse with cam swap .

 

[cEN]

okay thanks for the quick replies, i figured i'd ask here since you guys seem to flame stupid questions less than most boards haha

 

[sweetk30]

just to make you feel at home your question

 

[cEN]

hahah thats much better

 

[USSkoval]

I agree, Thirdgen.org would be a great place to sell that cam, should go quick

 

[wage92]

seems like a really high lift cam for a lifted truck. Good suggestions above.

 

[cEN]

the motor isn't going to go into a lifted truck, wish i could put it in my blazer cause its about due, but i'm putting it into a 94 step side chevy, sadly street only no four wheeling for this rig

 

[sweetk30]

lt1 with opti spark better off not in mud truck. those things hate water to begin with .

 

[cEN]

good thing i'm not using the opti spark