Where can I get parts sand or bead blasted in Seattle area

Discussion in 'The Garage' started by wazzabie, Aug 28, 2005.

  1. wazzabie

    wazzabie 1/2 ton status Premium Member

    Apr 17, 2001
    Likes Received:
    Washington State
    My intake manifold is really looking bad. Since I have the carb off I figure I might remove it, put on some new gaskets and get the manifold bead blasted. Any good shops local in Seattle to do this and at what cost? What if I were to take a brush to it... might be just as good.

Share This Page