where to get parts?

[blazin_blazer]

I've installed a sye, where is the best place to find the male & female slip joint that goes in my drive shaft?

i found this, but i need the pieces like this that weld into the d-shaft that slide together.

http://www2.dana.com/expert/wc.dll?DSD~dedfscs~2~

 

[4X4HIGH]

Give Jesse a call at www.HighAngleDriveline.com

 

[blazin_blazer]

10-4 will do, thanks i've ordered these parts before for the same reason years ago, i ordered them from spicer & i had to cut my d-shaft 1st and have the d-shaft wall thickness mic'd to tell them the thickness(iirc it was .082 wall) of the d-shaft wall. will i need that info also for the link you gave me?

 

[blazin_blazer]

will they rework stock d-shafts, since the d-shaft came out of the lwb k30 that i got the trans/t-case, & axles. i need a swb d-shaft so it will need a section removed and the slip put in it, or would i have to buy a whole new d-shaft?

 

[4X4HIGH]

If you have a longer than needed shaft Jesse can cut and rebalance it. He can reuse the ends also unless you're going with a different series u-joint.

 

[blazin_blazer]

nope, i'm keeping the ends stock, just need it shortened and the male & female slip put in the middle....thanks for the info