Discussion in 'The Garage' started by **DONOTDELETE**, Mar 29, 2002.
i'd like to see the pic of that again if that is possible. thanks.
This is a picture of my K5 with an extended front shackle and an add-a-leaf rear lift (approximately 1" of lift) with 35" tires before I trimmed the fenders more than the front fender was already trimmed when I bought it: http://photos.yahoo.com/bc/allandd/vwp?.dir=/Greenblazer-AZ%27s+K5&.src=ph&.dnm=The+Project+begins.jpg&.view=t&.done=http%3a//photos.yahoo.com/bc/allandd/lst%3f%26.dir=/Greenblazer-AZ%2527s%2bK5%26.src=ph%26.view=t
This is a picture after my fender trimming:
This is a picture after my 1" body lift, and the fender trimming:
It is possible to run 35 " tires with no lift but it requires fender trimming... I think!
Here's mine, it wasn't pretty:
yours was the one i was thinking of. thanks to both of you though, that was just what i needed. i will be doing this to my work truck to keep it low and therefore easy to load tools into. putting my compressor into a lifted truck everyday sucks! thanks guys!
My dad had a 2 1/2 inch lift and 36's. It needed fender trimming bad before we could even drive it.
Shannon (mudhog) has you all beat...............2.5" Rancho lift (I sold it to him, so I know what it is) with 38" Swampers.............
Who needs trimming when you could just take off the fender's /forums/images/icons/smile.gif
you loan me the 35's and we will put them on.
i dont mind.
i have 33's and no lift. matter of fact i have stock springs with a bit of a sag. and a bit of trimming.
i figure when i get new meats for the blue beast i will put whats left of my 35 bfgs on my work truck. i've already cut the beast's fenders so i'm not afraid to cut another pair!/forums/images/icons/smile.gif
Separate names with a comma.