I have a 87 blazer that I'm trying to figure out wiring. Red 10awg wire that has a fusable link at solenoid and runs in loom to fuseblock but it was cut by distributor and there's a 12 awg wire that continues to fuseblock. Is there suppose to have a junction block where the wires are cut drivers side of distributor? If so can someone take a pic of there set up? Thank you in advance. Project almost done. I did connect the 2 wires with a butt connector and truck runs but want to make sure I wire it correctly.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Wiring
- Thread starter PHC CK5
- Start date
Mean this? Yes 87 K5
