What's new
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.

WTB: 4l80e Controller & 4l80e - Fig 8 205 Adapter

P

PsRumors

1/2 ton status
Joined
Nov 11, 2006
Posts
626
Reaction score
0
Location
Cartersville, GA
Before I order new equipment from Compushift and Advance Adapters I figured I would check to make sure no one was needing to get rid of there stuff.

Needed: Compushift 4l80e Controller
Advance Adapters 4l80e to figure 8 NP205 adapter PN 51-0410

Just shoot me a PM or respond here.

Thanks
Ron
 
I read all of it about the machining and spacers etc. I am not a machinist and don't trust any locally. Figure the AA adapter will be easiest.
 
AA is going to be pretty expensive. if u can get all the measurements and take it to a guy locally, im sure it can be done pretty easily
 
If you have or are going with a figure eight transfer case, I don't think you will need a spacer. The spacers are used with the round style transfer cases because the round 400/205 adapter mounting feet will not clear the 4180 pan. Sorry to confuse you.
Jimbo
 
Jimbo* said:
If you have or are going with a figure eight transfer case, I don't think you will need a spacer. The spacers are used with the round style transfer cases because the round 400/205 adapter mounting feet will not clear the 4180 pan. Sorry to confuse you.
Jimbo
Click to expand...

look at my posts in the big thread. i needed a spacer as i used a 2x4 fixed yoke tranny. and if you use a 400 adaptor you still need to machine the seal lip down a bit.
 
You must log in or register to reply here.

Latest Posts

Top Bottom