WTB Chevy D44 large bearing spindles

[Texis]

Need a set of Chevy Dana 44 large bearing spindles for 3/4 ton internal spline hubs. Picked up a used set of hubs and spindles a couple of years back and the spindle are crap. Went to clean them up and install this week and they are shot, pitted, out of round, etc, etc. I need to find a GOOD-USEABLE set.

Thanks

 

[sweetk30]

if I recall all internal of 3/4 ton and 10 bolt 1/2 and 3/4 ton are large bearing .

just early dana 44 was small bearing stuff till mid 70's

 

[thatK30guy]

Just to clarify to anyone else checking this thread, you need the 2nd design, '77-on up to '91 spindles. And yes, as quoted to fit the internal bearing hub design, too.

 

[Texis]

Found a set on Ebay, done. I hope I have better luck than my last used set.

Thanks Guys

 

[kennyw]

Found a set on Ebay, done. I hope I have better luck than my last used set.

Thanks Guys

That is too bad, I probably could have saved you some cash. If you want good spares, I have a couple nice spindles for $10 plus shipping for the pair.

 

[Texis]

for $10 bucks plus the ride I'll take'um. PM Sent