14 bolt axle perches and shock tabs

[burban1500]

Who sells them?

When welding the 14 bolt into place, do i want the pinion pointing straight at the driveshaft or should it be facing down slighty to achieve the best angle to kill any vibration

 

[SCOOBYDANNN]

www.ruffstuffspecialties.com

I buy everything I can from Dan.

 

[CDA 455]

Who sells them?

When welding the 14 bolt into place, do i want the pinion pointing straight at the driveshaft or should it be facing down slighty to achieve the best angle to kill any vibration

I want the pinion pointing straight at the driveshaft. <--This is correct !

 

[YZEATER]

to do it correctly, you need to have weight on the axle and pointed slightly down from parallel to the shaft , 1 or 2 degree's, that is with a cv joint. if you just have 2 u-joints, you want to match the angle with the t-case out put, and then maybe 1 or 2 degree's down.

 

[cbbr]

Kert at www.diy4x.com made mine. I wanted the perches to be taller to get rid of the arse sag look. Great stuff.

 

[divorced]

I like Kert's perches too because they are available a little taller.

 

[burban1500]

wish i had seen the diy ones that give you a little more lift before i ordered the perches from ruff stuff, o well.
​

h