14 bolt rear how many degrees !

[the general]

i am building an 14 bolt ff but wanne now the maximum degrees i can rotate the axle for the best driveshaft position , is there a maximum ? it,s for a 75 k5 8 inch lifted (superlift set ) it has a np 203/th350 combo that i am gonna chance to a SM465/205 combo the vehicle is used for 95% on road (60/70 miles an hour)

hope too get some good answers

 

[shaun89]

u want a normal driveshaft to operate at 3* but if ur running a CV shaft then u want the operating degree to be around 1-2*, just to make up for axle wrap when on the gas, it will run around 0* which is what u want with a CV shaft. so u have to put the shaft in. and get a degree finder and see what ur working with, then buy the correct shim to bring it up to what u need.

 

[76zimmer]

This might enlighten the subject:

http://www.4xshaft.com/index.html