1480 d60 and 205 yokes

[twoslo4five0]

does anyone know if someone makes theese??im thinking of making a square front shaft out of d60 stubs but i can find a yoke for either...my 205 is 31 spline btw

 

[RGV72BLAZER]

I'm planning on doing the same, already have my stub shafts, but can't seem to remember how the axle/t-case yokes are gonna work...lol. I'll look for it later on today & see what I figure out.

 

[nvrenuf]

Kert is working on a similar set up but he's building a D60 yoke welded to a custom flange.

 

[RGV72BLAZER]

yep D60 stub to a flange, giving ~42* of angle...good write up on it over on pirate

 

[muddermilitia]

Kert is working on a similar set up but he's building a D60 yoke welded to a custom flange.

High angle driveline does sell d60 1480 yokes btw.

As for the t-case yokes, I beleive its gonna be a custom made item. Have you seen the write-up on pirate4x4?

 

[RGV72BLAZER]

i have...cheap & very effective. got one set of stubs for $50.

 

[muddermilitia]

i have...cheap & very effective. got one set of stubs for $50.

I can get em for free

 

[deadlew]

Your front output is 32 spline. I might have a yoke that may work for your T-case. PM me the demensions and I'll check.

PaulC

 

[nvrenuf]

yep D60 stub to a flange, giving ~42* of angle...good write up on it over on pirate

This is going to sound dumb but do you have a link? The only one I've seen was using D44 parts.

 

[Hogback Fabrication]

This is going to sound dumb but do you have a link? The only one I've seen was using D44 parts.

http://www.pirate4x4.com/forum/showthread.php?t=549625


You can buy 1480 yokes for a 205, I don't know about for a 60.

Ford 205's have a 31 spline input and two 32 spline outputs.

 

[nvrenuf]

Thank you sir That should make for a nice afternoons reading while I'm screwing off at work.

 

[twoslo4five0]

thanks guys!!if i make one of theese its deffintiley gonna be a stout front shaft...

 

[deadlew]

Just hope it isn't stouter than your front axle pinion gear or NP205 front output. That would be a cool break broken Dana 60 pinion gear or a 32 spline np205 front output.

PaulC

 

[muddermilitia]

Just hope it isn't stouter than your front axle pinion gear or NP205 front output. That would be a cool break broken Dana 60 pinion gear or a 32 spline np205 front output.

PaulC

hmmm that sounds like a challenge

 

[twoslo4five0]

H.A.D is no longer selling the d60 1480 yokes and knows no one that is...i guess thats preety much out

 

[walla2k5]

I can get em for free

I'll take a couple. Send me a PM.

 

[RGV72BLAZER]

I'll take a couple. Send me a PM.

X2 i'll cover shipping