You don't have to quit going just because I am. I'm sure @ktmoutfront is going to do a fine job and you need not be concerned.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
1982 C/K 6.0L Caitlyn Mall Crawler (Interior time)
- Thread starter Babaganoosh
- Start date
The comedy relief should be pretty good!
never stops.
I really want to go but just dumped 1500 into my daily and I owe 1700 on taxes.
Funds won't allow the truck to come. If I do I'll have to ride shotgun with someone.
Funds won't allow the truck to come. If I do I'll have to ride shotgun with someone.
I didn’t mean to like this... sucky man...
You know you can unlike stuff also if you change your other mind!
Wish I could unlike what I said.
I am going to be offended if you don't show up Ben. Why did I spend all that time teaching you how to sell raffle tickets last year?
I really feel bad I might not make it, it's the big year. I probably will have to call reinforcements.
Just need to put the rear driveshaft in, tcase fluid, cross member and top off the trans if needed.
Who ever put the tag check for balls in deserves a pat on the back.
Who ever put the tag check for balls in deserves a pat on the back.
either quit making so much or get more taken out in taxes
Are we talking about balls?
no talking $$$
I didn't realize it but in 2016 I was just shy under the next bracket. 2017 I went over by a couple thousand.
Topping off fluids, it moved to the street.
Less fluid leaks but the tcase is dry. On to the next leak.
transpan leaks because I installed one of those diy drain plugs and the pan gasket. Who makes a good after about pan with a usuable drain plugs?
transpan leaks because I installed one of those diy drain plugs and the pan gasket. Who makes a good after about pan with a usuable drain plugs?
I have one of those derale pans with the “cool tubes”. I’d pass. The tubes fill up with dirt and do nothing and the trans temp location put it right in the way of the driveshaft. Had to plug it and use an add a port into the opposite side of the pan.
Hmmm, didn't think about driveshaft clearance.
Pml makes nice pans. https://www.yourcovers.com/transmission_pans.html
