mjfoster49
Registered Member
I put in a new motor in January, and converted it to propane. The transmission is a 700r4, and a clocked transfer case.
The front driveshaft is square with stock size joints. The rear is a tom woods shaft with a 1350 cv and a 1410 u-joint.
The front axle is a dana 60 with 4.56 gears, welded, crossover steering, and hydro assist.
The rear axle is a 14bolt with 4.56 gears, and a detroit locker.
The front suspension is 4" springs, and the rear is a shackle flip with 56" springs.
Tires are 39.5" irok's
I have two sets of doors, one stock set, and some half doors. I have also dovetailed the bed.
I will try to take some new pictures tomorrow. It has a few more dents since this picture was taken. The truck is located in South Georgia. I can also help with delivery. I am asking 5,000 obo.
The front driveshaft is square with stock size joints. The rear is a tom woods shaft with a 1350 cv and a 1410 u-joint.
The front axle is a dana 60 with 4.56 gears, welded, crossover steering, and hydro assist.
The rear axle is a 14bolt with 4.56 gears, and a detroit locker.
The front suspension is 4" springs, and the rear is a shackle flip with 56" springs.
Tires are 39.5" irok's
I have two sets of doors, one stock set, and some half doors. I have also dovetailed the bed.
I will try to take some new pictures tomorrow. It has a few more dents since this picture was taken. The truck is located in South Georgia. I can also help with delivery. I am asking 5,000 obo.
