20 years and still not done

[Lizarddog]

Love it. Keep up the good work!

 

[Lieferson]

awesome story, Says you're in spanaway.. right down the road from me. Maybe ill see ya cruisin around some time..

 

[fastazz81]

You may

 

[bix]

looks wicked

 

[Bent77]

I'm just here to facilitate that office pool.

You know, how far will this thing fling dirt clods?

 

[fastazz81]

I've always been to busy pointing it the direction I wanted to go, but I'm told it really lets the mud fly high and that it throws the mud flaps back up against the tailgate

 

[fastazz81]

So bringing this back from the dead.
I have been working on it here and there got passengers side floor board and rocker panels replaced.then I replaced the rusted pedal assembly that would no longer move , I suppose it has sat way to long.

 

[fastazz81]

And since I’m planning on trying to make it to blazer bash this year I pulled the motor that was in my race car out of it,and then put a tbi tank in and ran fuel lines and reinstalled the motor that had a power band below 4500.and installed the steering brace that’s been on my work bench for a couple years.

 

[fastazz81]

Still need to move axle forward , trim front fenders, install front driveshaft,swap out t-case, install winch,burn in rear spring perched and shock mounts , get shocks and probably at least a dozen other things I haven’t thought about yet.

 

[Bent77]

You have time. But you’re gonna be busy

 

[fear_nothing]

2019 bump?

 

[beags86]

C10 build thread to?

 

[fastazz81]

Definitely need to update this.

 

[fastazz81]

C10 build thread to?

That may take a little bit , I’ll have to go over to my parents and dig through picture albums. Short story is my parents bought it brand new in 81 and I’ve been washing, wrenching on and driving it ever since.

 

[fastazz81]

 

[fastazz81]

Anybody have any pictures on how they ran the hoses from the box to the cylinder?

 

[beags86]

Been working on the blazer getting ready for blazer bash.

Bump

 

[fastazz81]

Got the hydro assist all plumbed and bled it’s amazing how easy it is to turn the wheel now.

 

[fastazz81]

Then decided to fix the quarter panel enough to put a tail light back in it . Used a c clamp a tow strap and my truck to pull it out.

 

[Bent77]

Don’t look too bad, considering