i was wondering, since the 4L80E uses the long 32spline input, is it the same input as the 32spline sm465's?
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
4L80E and sm465 same input?
- Thread starter muddybuddy
- Start date
atho
1/2 ton status
do you mean output? the sm465 has the small 10 spline input.
muddybuddy said:
Afaik, once the 205 changed to the round bolt pattern ('85+) all of the input shafts are the same.
Jimbo*
1/2 ton status
Muddy, what are you up to?? What are you trying to figure out?
Jimbo
Jimbo
haha im going to swap in the 4L80E and then run blackbox to the 205. im just checking to see if they use the same inputs on the t-case so that if later down the road i decided to swap in a sm465 i wouldnt have to swap inputs on the blackbox. thats all 
atho said:
the newer ones with hydro were 32spline
muddybuddy said:haha im going to swap in the 4L80E and then run blackbox to the 205. im just checking to see if they use the same inputs on the t-case so that if later down the road i decided to swap in a sm465 i wouldnt have to swap inputs on the blackbox. thats all
Yup ya wont have a problem...
Jimbo*
1/2 ton status
X2. You're doing it right the first time.
Jimbo
Jimbo
Jimbo* said:
perfect! thanks guys
atho
1/2 ton status
muddybuddy said:the newer ones with hydro were 32spline
oh...the input of the transfer case itself...i thought you meant of the tranny...doah
