'90K5 241 with SYE and HAD CV Flanges - SOLD!!!

[DPI]

1990 241 Transfercase with HAD SYE and front and rear 1350 flanges. This is the electronic speedo version.

$450 AND I WILL COVER SHIPPING!

These are the prices from www.highangledriveline.com where all parts were purchased and installed a couple years ago. I doubt there is more than 200 miles on the setup since the upgrade.

This is a picture from HADs site and this is my case...

Current Pricing from HAD:
SYE - $339
Flanges - $109 each.
Total cost of new parts = $557

So for less than the cost of parts, you can have the entire setup ready to install.

The only reason I am selling is to make room for my new 4.3 Atlas II!

 

[muddybuddy]

man thats a sweet deal! if i wasnt already sold on the idea of a doubler id be all over that

 

[Leper]

Shipping to 75080 business address?

 

[DPI]

Shipping to 75080 business address?

Shipping will be $50 to that zip.

dp

 

[84zz4ss]

Shipped to 32506 business?

 

[DPI]

Shipped to 32506 business?

$55 to your zip.

dp

 

[jayweb]

DAMMIT - I just bought a rebuilt case - wish you had this up @ a week ago. what kind of shape is the case itself in? recent rebuild? just for kicks - shipping to 27312? I may bite the bullet anyway.

 

[DPI]

Shipping is $56.

The case seems to be in good condition. I have had zero issues with it. I know the previous owner ran synthetic fluid in it and I have continued to do that.

 

[DPI]

ttt

 

[wayne]

That is a good price. I'm not interested in the case since I already have the same set up except for the front output which is my question. Do you have a custom front output flange? If so what is it and what front shaft are you running?

 

[DPI]

That is a good price. I'm not interested in the case since I already have the same set up except for the front output which is my question. Do you have a custom front output flange? If so what is it and what front shaft are you running?

The stock front flange is used but was sent to HAD for machining to work with their 1350 CV joint. I am running the HAD 1350 CV front shaft...

 

[DPI]

I will cover the shipping.

This is getting close to going on EBAY if there is no interest on CK5.

 

[jayweb]

Pm'ed You

 

[DPI]

Got the PM and sent one back to you.

 

[jayweb]

back at you

 

[eblick]

I'll take it! If it is still available. Pm'ed ya.