RockBottomRacing
1/2 ton status
Long story short, I have to downsize until my wife finishes school, sold my diesel and now need my 91 V2500 Burb road ready. Got some tires for her, she runs and drives great, needs paint (another story).
Here is my plan so far, based on necessity.
Front wheel bearings
Locking hubs
front brakes
Tie rod ends
Drag link ends
Removing cat and muffler, clamping on a Flowbastard
Fluid changes all around
Now, this truck was purchased as an off-road rig only, and will still be built for that purpose, albeit a little slower and different choices for road manners (for now). I’m planning on doing DIY4X’s shackle flip n switch for the rear and 4” lift springs up front and zero rates all around so I can run the 35’s I already had for her. For now she’s gonna be on stock tires. I’m confident in the Burb as a daily, doesn’t smoke at all, shifts great, even overdrive (4L80e tee hee).
So what else should I throw in? I have a set of Doug Thorley Tri-Y’s I’m gonna install at a later date to eliminate the shitty y pipe and cracked manifolds, and I have a Vortec fuel pump on the shelf from my old K5 project. What else am I missing from the equation? Would love any and all ideas!
Thanks guys!
Here is my plan so far, based on necessity.
Front wheel bearings
Locking hubs
front brakes
Tie rod ends
Drag link ends
Removing cat and muffler, clamping on a Flowbastard
Fluid changes all around
Now, this truck was purchased as an off-road rig only, and will still be built for that purpose, albeit a little slower and different choices for road manners (for now). I’m planning on doing DIY4X’s shackle flip n switch for the rear and 4” lift springs up front and zero rates all around so I can run the 35’s I already had for her. For now she’s gonna be on stock tires. I’m confident in the Burb as a daily, doesn’t smoke at all, shifts great, even overdrive (4L80e tee hee).
So what else should I throw in? I have a set of Doug Thorley Tri-Y’s I’m gonna install at a later date to eliminate the shitty y pipe and cracked manifolds, and I have a Vortec fuel pump on the shelf from my old K5 project. What else am I missing from the equation? Would love any and all ideas!
Thanks guys!

