88trailblazer
1/2 ton status
Anybody have pics of a Zero Rate or Ez-Inch that has been milled to compensate for poor pinion angles?
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Angled Zero Rate or EZ Inch?
- Thread starter 88trailblazer
- Start date
Mmm. If he's gonna have a ZR / EZI *anyway*, I'd rather see the thing be milled, as opposed to stacking the ZR/EZI and a shim under the spring.
There was a thread about this the other week, and the stack of stuff involved was mildly frightening.
I know that both bolt through the spring pack, but it's still a lot of pieces.
-- A
There was a thread about this the other week, and the stack of stuff involved was mildly frightening.
I know that both bolt through the spring pack, but it's still a lot of pieces.-- A
JKW makes them. I've got some 4 degree ZR's into a true 1" at the thinnest part.
I also had him make some 8 degree ZR's, also with the thinnest part at 1".
I also had him make some 8 degree ZR's, also with the thinnest part at 1".
88trailblazer
1/2 ton status
Would you happen to have pics of them installed or not? Also did you move the axle?
88trailblazer
1/2 ton status
that was my post last week. Since I have go through the expence of a longer ubolt I'm looking at all my options.
