Nice truck. I don't know much about the 1/8th mile but using your conversion of 1.65 I think you will run just below 10.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Any predictions on my 1/8 mile time?
- Thread starter Low76K5
- Start date
Low76K5
Registered Member
9.89 Best
It came out of the hole great with a 2.17 60 ft time but didn't pull hard over 4500 RPMs and most runs it would lay down or stumble. I think I need a bigger carb, or at least hog out the Q-J. Seemed to pull harder and quit stumbling up high as the night cooled off, but my times didn't improve.
I will try again in a month or so after I get the fuel delivery figured out and add slicks. I hope to get in the eights.
Scott
It came out of the hole great with a 2.17 60 ft time but didn't pull hard over 4500 RPMs and most runs it would lay down or stumble. I think I need a bigger carb, or at least hog out the Q-J. Seemed to pull harder and quit stumbling up high as the night cooled off, but my times didn't improve.
I will try again in a month or so after I get the fuel delivery figured out and add slicks. I hope to get in the eights.
Scott
4xcrazy
3/4 ton status
1/8 mile,,,,,,,,,,,,,,,,when i heard about this on TV awhile back,,i was thinkin,,,WTF??? half assed drag racing???
run it the full quarter and wrap that motor up like your supposed to do !!
run it the full quarter and wrap that motor up like your supposed to do !!
steve_kibbe
1/2 ton status
I'm sure you'll make it into the 8's when it running right.
54inches
1/2 ton status
check the size of your fuel line.......you need at least 5/16, but I would use 3/8.........alll the way back
