Atlas II Transfercase Installed with a couple Pics

[DPI]

Still have some work to do - Lengthen rear shaft, shorten front shaft, grind on HAD front shaft to help with the angle, install shifters, weld up floor board where cut to clearence, ect.

Here's a couple shots of the crossmember I fabbed.

 

[wayne]

Looks sweet. Which gear ratio did you get?

 

[DPI]

Looks sweet. Which gear ratio did you get?

I went with the 4.3:1. Also changed my gears to 5.13 from 4.56:1. Should have a good crawl ratio now. The 42's suck up the gear and horsepower...

 

[rdn2blazer]

nice job!

 

[nvrenuf]

SECKSY!!!!!

 

[Chaddy]

looks good

 

[DPI]

Here's a picture of the previous setup.

 

[SkulzNBonz]

Good lookin' set up Daniel. I thought it may have been going to project rockwell.

John

 

[DPI]

That was the plan. But, I burned up the tranny in the '90 and the other tranny and Atlas were just sitting there....

The Atlas install was a little more complicated than I thought it would be. But it's coming together nicely!

Can't wait to try out the twin sticks!!!

 

[Citizen Rider]

What was your previous set up?

 

[OL14BLAZ]

Looks good man!!

 

[sledheadak]

looks real nice.

 

[DPI]

What was your previous set up?

It was the NP241 with the SYE from HAD.

 

[drivelineman]

nice - i was happy just to get my stak in mine- Jess

 

[jayweb]

DP - in a year or two when you get tired of that setup, will you sell it to me for what I paid for the 241? j/k!!!! (but that would be sweet)

 

[DPI]

DP - in a year or two when you get tired of that setup, will you sell it to me for what I paid for the 241? j/k!!!! (but that would be sweet)

lol Doubt this setup is ever coming out. However, the next project may have a Stak case instead.

I ground on the tranny a little to make it work with the 1350 HAD. I took it for a test drive yesterday. All I can say is 4.3:1 is LOW! And it is nice to have a twin stick.