Lots of progress made though.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Back In the Saddle Again
- Thread starter K5Devil
- Start date
Lookin good!
Only 105° in the shade
Hanging by the Ubolts now. Welded in the spring perch.
I will tell you that my ORD custom springs are thick enough for my drag link to rub a little at full left turn. High mount tie rod could be the same situation. Something to watch out for.
Well right now I have the tierod on the original tapered arms. But its weird because the PS knuckle is tapered for above and fhe driver side tapered for below. Just blew up my drill chuck so im running it that way for the time being haha
I do have another question maybe you guys can chime in. The ORD tie rod ends come with 2 boots per tie rod? Do you run them both at the same time or is it one or the other?
The instructions that I got with my last tie rod say to take off the boot that's installed on the rod end and use the ORD one that's included separately. I believe they're the special Kevlar infused boots.
I probably should have read the instructions lol
Just need tall arms not leaf springs
That flat top pass knuckle you got from me came off a 80's vintage 10 bolt
Yeah not sure. But the taper is wide at the top on it. Not the bottom. My other axle and the driver side knuckle are opposite
Got everything done except.
Torquing the U blots, attaching calipers
And wheels and tires. Pretty short list of things to get done.
Torquing the U blots, attaching calipers
And wheels and tires. Pretty short list of things to get done.
You got lucky
Where can i buy em?
Dana 60 Raised Steering Arms
Northwest fab is proud to offer the most thought-out and highest quality steering arms in the off-roading market! Our Dana 60 Steering Arms are the most feature packed Steering Arms available. Get that Tie-Rod out of harms way! All of our Dana 60 Hi-Steer arms have been engineered with Ackermann...
northwestfab.com
How many bolts in knuckles 3 or 4
Dana 44, Steering Arm Spacer, 1/2", (PM0050)
You've selected the 1/2" rise steering arm spacer for a Dana 44. They will work on the driver's or passenger's side; just flip them over! If you need them for both sides, be sure to select a quantity of 2.WARNING: These are sold individually! With most steering arms, a 1/2" spacer with work...
www.partsmike.com
Might need new studs as well
Sweet im going with the 1" thick ones as there will put everything where it should have been.
