Bro flo XT ?

[Chevk587]

What’s up guys I know a lot of you are using this setup but are any of you using the XT version ? I’m trying to figure out my throttle linkage . Everything connects on the opposite side from where the OE cable did . A quick search brought up brackets but nothing on the cable it’s self any suggestions?

 

[mrk5]

I thought about using one, but I figured trying the connect the TH350 kickdown linkage would have been a real pain in the ass. Although I guess I could have just left it unhooked. But I searched like you and didn't find much info.

I think you could use the same solution as people that put the LS motors in squarebodies. I think the linkage is the same situation.

 

[skunked]

I use an aftermarket universal lokar setup that would probably work for you. I’ll find some photos and post them.

 

[Chevk587]

I use an aftermarket universal lokar setup that would probably work for you. I’ll find some photos and post them.

Thank you sir

 

[sweetk30]

throttle cable could be a 96 chevy truck vortec 350 cable . still clips in the firewayy and pedal the same but longer to do the loop to the right like the XT unit needs .

 

[dyeager535]

Looks like what TPI used as well, from the little bit I can see if it. TPI is probably the same or similar to Vortec. My TPI cable is way longer than it needs to be for some reason. Probably how it was routed on cars given the more cramped engine bays.

Opposite side, maybe flipped over? A bit of digging would probably net a better picture: https://www.corvettemods.com/C4-Cor...MPjFCkABYjK_C9jwRt1rp-CkU7vWN5ihoCtm4QAvD_BwE

 

[diesel4me]

Some older GM cars used a TH350 detent cable hooked up at the accelerator pedal..I think later 70's Monte Carlo's had that setup..

 

[skunked]

Here's the setup I use on both K10's, one with FiTech and the second with pro flo 4.
Lokar Cable (longer are available and they're cut to fit) https://www.summitracing.com/parts/lok-tc-1000ht

Remove the gas pedal and install a tab for the lokar cable clevis.

painted and the lokar cable/clevis installed

I used the stock throttle cable hole on the firewall with a couple washers. Disregard the attachment point on the throttle body linkage side, I moved that up later.