Bushwacker fender flares and 3" lift

[aggieboy]

I'm wanting to keep my body pretty low to the ground but run about 35's. Does anyone know how much is trimmed with the cut out flares? I saw a guy today with a 3in body lift and 35 12.50. He only had a problem with rubbing when he went into a steep driveway pretty fast. I baby my blazer and the worst it sees is just some rough hunting roads. Would i be fine with the cutouts and 3in lift? Thanks in advance

 

[original balzer]

I could be wrong but I belive the cutout flairs take a pizza slice out about 1" wide and 4" tall from both front and rear of the wheel openings.

My K5 had 3" and cut fenders and cleared 35's. Then I went to 38's and they clearanced the fenders all by them selves.

Balzer

 

[gmc4cw]

to install the cutouts you will need to cut the fenders back to the inner liner.

http://www.bushwacker.com/Instructions/40003_40004.pdf

 

[cbbr]

Yep. About 3" on the bottom and 1" on top. If you only have a little rubbing, they should work.

 

[aggieboy]

thanks for the help. I think ill go with that setup for my truck that way I don't alter it too much and get some problems i hear some guys start having with angles and such.