CA - Axles - Military CUCV, Dana 60 Front, 4.56 and 70" 14 Bolt, 4.56

[1972Blazer]

$4000.00 plus shipping

The axles are located in Carlsbad, California (Southern Calif).

Please send me a PM or post and I will get back with you. Thanks in advance!

 

[1972Blazer]

I have a complete set (NOS 69.5" WMS CUCV 1 1/4 Ton Dana 60 and Van 70" WMS 14 Bolt with Disc Brakes). They are 1/2" of being the same width front and rear.

They have 4.56 gears in both, the front is brand new NOS and the rear is completely rebuilt.

The Dana 60 has the Trac-Lock and Mile Marker Stainless Steel Locking Hubs. The Dana 60 is an NOS CUCV Axle purchased from a government auction.

The 14 Bolt has the Open Carrier for the Detroit Locker. The 14 Bolt has been shaved of Spring Pads and Shock Mounts. The 14 Bolt is a 1973 Van Housing with all new internals except the Original Carrier, Hubs and Axles.

I have the Brake Calipers for the Dana 60 but not the 14 Bolt, I can get the rear calipers for the buyer if desired.

I will only sell them as a set.

They have been Media Blasted and Painted and are ready to install.

 

[TDAWG1]

so nice and so pretty. wish I could cause I would... Drool

 

[midnitewarya]

That price is nuts!

 

[rdn2blazer]

That price is nuts!

Ok, good, I was not the first to say it. X's 2! Just a little out of line don't ya think?

 

[GreenieK30]

It is a fair price for a basically a brand new set of 1 ton axles. It is easy to spend $4000 in parts building axles, all the parts add up quick.

 

[1972Blazer]

That price is nuts!

Ok, good, I was not the first to say it. X's 2! Just a little out of line don't ya think?

It is a fair price for a basically a brand new set of 1 ton axles. It is easy to spend $4000 in parts building axles, all the parts add up quick.

The cost to build these so they are like new is more then the asking price. Everything is new except the 14 Bolt Housing, 14 Bolt Axles and Open Carrier for a Detroit.