calling everyone that runs boggers on the street

[bigbadchev84]

I am running 35x16x15 boggers on my daily driver, I have been hunting a vibration that I have had on my last two trucks. I ran 39.5 boggers on the last, the vibration wasnt as bad as it is now.

When you are comming to a stop, does the rig vibrate and shimmy a bit? Like 15miles an hour and below?

 

[YZEATER]

that would be the lugs hitting the pavement.

 

[89blue1500]

my Jeep with boggers does the same. 35/10.5-15

 

[1-tonmudder]

I have ran 4 sets of Boggers in different sizes and they all did that.

 

[jekquistk5]

My radial claws did that at 10 miles per hour, just the big lugs.

 

[b454rat]

I had 2 sets and neither did that. I felt the lugs at real low speed, like letting off the brake and just coasting sorta. But what I think your are feeling is the tires being out of round. Egg shaped in an extreme way....

 

[Cajun4x4]

hmm my unbalanced 38.5 boggers never did that... infact they rode better than my balanced XMLs

 

[gmc4cw]

I ran almost that exact same size except they were 16.5's. how wide are your rims? what air pressure are you running them at? how do you have them balanced?

I could always feel the lugs slapping at really slow speeds but not at 15 mph.

 

[bigbadchev84]

My old ones were balanced with equal, these ones are just wieghts on the rims, I am running a 15x10" rim and running 23lbs of air in them. I know what an out of round tire feels like this is not it. They get flat spots in the mornings but it is gone in a couple miles.

It does fine at hiway and cruising speeds it is 15mph and down, only when comming to a stop. The whole truck rattles, I had it chalked up to bad driveline angles, but it still does it after my HAD shaft. I will be getting some new toyo radials the first of june.

 

[protechk5]

i ran 39.5 ones and it did that from 10mph or less

 

[gmc4cw]

I will be getting some new toyo radials the first of june.

then whats the point of the thread?


and your rim is not wide enough for those tires.

 

[bigbadchev84]

then whats the point of the thread?


and your rim is not wide enough for those tires.

I have been chasing vibrations on this thing forever. It was just recently brought up as a possible cause I have already thrown $550 at a new HAD shaft that I probably needed anyway, But it didnt fix the problem.

 

[mp1472]

I just bought a rig it has 38 " thornturds on it ... it rides so terrible i couldnt even imagine what boggers would be like! i had it up to about 50 mph it was freakin scary and around 10 mph it jus feels like youre driving over a rutted out beat up road even though youre not. I jus got some more street friendly tires.