Can i see how you guys mount your hi-lift jacks.

[Mr. Pickle]

Is that a purchased or home-made mount?

You COULD try these mounts as well. This was my old setup, b4 I line Xd my interior and did away with the side panels.

 

[badmix]

Both. lol..its a bracket I bought, but had to extend to reach the bed rail. They hold the axe/shovel very well.

http://www.nationalfirefighter.com/product_info.php?products_id=99

 

[walla2k5]

Here's an older pic. I used tube collers to attach to the roll bar.

 

[Desert Rat]

At the SEMA show Hi-Lift showed off a new mount that isn't on their website yet but it is a mount that allows you to put your Hi-Lift on round or square tubing. There is a picture of it on p77 of the March 09 4Wheel & Off-Road magazine. I will most likely get it and mount my jack on my roll cage in the rear.

 

[Avery4jc]

 

[abig84]

thats pretty neat. that would even work for the k5s too.

 

[Avery4jc]

yep, you'd probably just want to drill a small hole in the top so it'll sit flush over the bolt head if/when you want to put it on.

 

[colbystephens]

or you could use the existing holes by cutting out the cage nut under the bed rail and using a typical bolt and nut set up.

very cool, avery! i might have to do something similar. i was going to put it on the bumper, but what you've done looks real clean and out of the way!

 

[boz42]

Here is mine: