opfor2
1/2 ton status
In a past post someone talked about cleaning the MAP sensor and related vac ports. How would one properly clean the sensor and port ?
Dan...
Dan...
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
cleaning the MAP sensor
- Thread starter opfor2
- Start date
Thunder
3/4 ton status
I have cleaned MAF sensors but have never cleaned or know any way to clean a MAP sensor. They either work or they dont. I would think you would damage it if you tried to clean it.
I guess you could clean the electrical connection and check the Vac lines and ports to make sure they aren't plugged or pinched. Sometimes the Vac ports on the manifold will get carboned up.
I guess you could clean the electrical connection and check the Vac lines and ports to make sure they aren't plugged or pinched. Sometimes the Vac ports on the manifold will get carboned up.
opfor2
1/2 ton status
thank you. I guess i'll just clean and check the hose.
