badger red
1/2 ton status
Is there a minimum amount of suspension lift required (for clearance purposes) to use the ORD crossover steering for either the dana44 or dana60?
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
crossover steering
- Thread starter badger red
- Start date
It starts getting tough to fit all the parts below about a 3" lift. And really below that height the factory steering works pretty well for the uses that a 3" lifted full size will serve.
Are you looking to go lower than that? It's possible, just not as easy.
Are you looking to go lower than that? It's possible, just not as easy.
badger red
1/2 ton status
Stephen--thanks for the info. I was planning on a 4" lift, no more than that, as I don't want to get too high--I'll cut sheetmetal if necessary. I checked the ORD website and didn't see a minimum lift dimension in the crossover steering section (hope I didn't overlook it!).
It might not say on the site, but there's very limited demand for crossover with less than a 4". So in your case, no problems. In fact, the majority of our kits are with 4-6" lifts.
