sawzall
Registered Member
I am going to end up having to put a spacer on my dana 60 steering arm and while i do not like this idea, i was wondering since i have hydro assist, how much stress does the arm see anyway? any ideas?
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Crossover w/hydro assist ?
- Thread starter sawzall
- Start date
You have crossover but still need a steering block, is that right?
If so, I wouldn't worry a lot, hydro assist takes stress away from the mechanical part of the system.
If so, I wouldn't worry a lot, hydro assist takes stress away from the mechanical part of the system.
Fred_M1010
1/2 ton status
How much do you need to raise it?
Most spacers I've seen are 2-3" tall.
If you don't need that much raise you could get a raised steering arm instead.
A new steering arm doesn't cost much more than a spacer.
Most spacers I've seen are 2-3" tall.
If you don't need that much raise you could get a raised steering arm instead.
A new steering arm doesn't cost much more than a spacer.
Virginia 4x4 has steering arms that are 2inch thick, machined on both sides, gives lots of clearance and only 130.00...
sawzall
Registered Member
yeah, the ballistic one is about what i have (since theyre local). where do you guys source your longer studs?
iirc, Ballistic has them too, with that spacer in mind....
thats another one NWF SCREWED me on....
thats another one NWF SCREWED me on....
