CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.

CUCVs and a k20 Project truck In North New Jersey. M1008 m1028 m1009 and m1031

84CUCV

3/4 ton status
Joined
Jul 1, 2002
Posts
7,150
Reaction score
2
Location
NJ for now
Hope the moderators don't mind the jam this all into one post. Still like these old trucks. However I'm not into them the way I was. Actually it seems like all I do is kill them at this point. Anyway, if its for CUCV I probably have it. A lot of what I have runs and drives. Some things need small work though. As it stands right now:
86 m1009 30,000 miles on it no rust. Great tires, new glow plugs And injection pump runs and drives. 5000

86 m1028 21,000 miles On chassis and axles. 4000 miles on 6.2 th400/208. no rust. Very very clean. New shocks, Hydro boost do other things I can't think of right now 6000

87 m1028 27,000 miles on it. No rust. One small dent. Very clean. 5000

86 m1031 Has about 30,000 miles on her or so. Has some rust in the floor cab corners. Body mounts are fine. Starts right up. Needs a break line and master cylinder. This is the one with the 205 and the PTO driven generator 2800

85 m1031 17,000 miles No Rust. few small dents. very good shape for a truck that came back from Iraq. Was stationed at Camp liberty. This one has the older M880 body with Gas driven generator/welder. 5000

m1031 21,000 miles on it. Little bit of rust. Nothing bad. Top end of the motor is not getting oil. Pulled out the injection pump for another truck. Pretty good shape for truck that was a Camp liberty as well. can include another 6.2. 3800

80 k20 Shorten frame. Down to 109 inch. 350 th400 205 fixed yoke 205. cucv axles are in that's about as far as I got. New 2 Wheel Drive steering box. New six-inch tuff country springs front and rear. All the suspension pieces are from ORD. $3500

Have all kinds of parts. Bumpers, Hummer tires, h1 bead locks transmissions, transfer cases, many 6.2 diesel, 1 dana 60 and 1 set of 1 tons left. Send me a PM post up. Whatever you like to do. Working on better pictures. also, if you need parts.. i get a deposit on the bigger parts so i know they are gone. ill cut it up.

Have a good night guys
 
Last edited:
also working on better pictures.. these pictures are a bit older. still the same for the most part really. everything is covered in snow..
 
you moved the perches for the cucv 14 bolt to fit in the k20 or you used k30 spring hangers?

do you have a 3/4 ton 14Bolt FF laying around?

any pics of the k20? miles? details? does it steer right now?
 
I took the perches off the axle. Perches are from DIY. No lose 14b around. If you look in the photo bucket you will see the truck. It has no bed on it. Still pretty much looks the same just has cucv axles. Not sure of the mileage. Runs perfect though. No it doesn't steer. I would say a good solid day work it could be finished off. Working on better Pictures
 
Yes pretty sure I have the shackle mounts for front and rear. k20 Needs a little work still. All the big stuff is done. Needs the rear brake lines finished off, fuel lines have the fuel tank for it. Steering needs to be finished.. I think that's it
 
Top Bottom