D60 center jacking

[76zimmer]

I use a 2x6 flat on the jack with a 4x6 angle cut to clear the diff, and screwed to the 2x6....what do you use to jack your D60 up in the center?

 

[nvrenuf]

A chunk of 6x6, it leans a little but not much and still gets the whole thing up to get stands under it.

 

[shady]

I use a 2x6 flat on the jack with a 4x6 angle cut to clear the diff, and screwed to the 2x6....what do you use to jack your D60 up in the center?

Your block was sweet dave that thing was even stable when in the air. I bet kurt could make a cheap marketable cradle that plugs right into the swivle hole on the end of a floor jack

 

[4X4HIGH]

I just slide my floor jack under the pumpkin and lift from there, so what if the truck leans slightly, just have to go a little higher before being able to get a stand under the driver side.

 

[82355]

I just slide my floor jack under the pumpkin and lift from there, so what if the truck leans slightly, just have to go a little higher before being able to get a stand under the driver side.

This.

Martin