Dana 44 Cross Over High Steer Arm Blowout!

Discussion in 'Vendor Forum' started by Dunks Performance, Feb 4, 2005.

  1. Dunks Performance

    Dunks Performance Registered Member

    Feb 2, 2005
    Likes Received:
    Springfield Oregon
    On special dana 44 steering arms, both long and short $59!


    These Dana 44 steering arms are machined from billet steel blanks, no hot roll bar stock that can bend, or water jetted flat stock. We taper them for Factory Chevy conical washers, and Chevy/Ford 1 Ton tie rod ends. They are available in a single hole style for those who just need crossover steering, and a 2 hole with second arm for full high steer. We have machined all edge's round to minimize stress risers, and added a 10 degree angle to eliminate steering bind, many arms do not have this feature.

    Call 541-726-1006 for ordering info


Share This Page