Dana 60 lockout stuck

[punx.inc]

I have a 1986 m1028 and need to replace the passenger side wheel bearing.
Here comes the problem. We can't get the hub out. We rempved both clips and it won't
budge. We tried a slide hammer, heat, pb blaster. We can't get it out. Any ideas?

 

[fallout232]

You removed the snap ring from around the axle and the large ring that runs around the perimeter of the hub edge correct? Can you post a pic up of the inside of the hub on what you have left to take out?

 

[01maroonz71]

wail on the hub(wheel hub, not the lockout) a few times with a sledge and block of wood. this happend to me on a superduty a few weeks ago and it drove me nuckin futts

 

[90'K5]

Can you get the outer bearing out of the hub/off the spindle? If not, the outer may be your problem. If you can remove the outer then, as Maroon said, use a block of wood and a bfh. Even if the inner bearing is stuck on the spindle you can still get the hub off if you can get the seal to separate from the hub.

 

[desertrat67]

He can't get the locking hub off to get to the bearing.

This guy: