CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Dana 60 parts
- Thread starter 76zimmer
- Start date
cowboypuller
Registered Member
interested in plates and sway bar could you tell me what it would cost to ship it to 63559. Thanks
Mr.Chevy4x4
1/2 ton status
I'll take the spring plates if not already sold? Thanks, Mike
Cowboy, I regret that another member inquired about them via PM, from the other thread I put up in the General parts section and has notified me again for the spring plates....I'm awaiting payment from him...IF the deal don't go through you are next up.
the sway bar is still for sale, and I will get a quote on shipping for that for you tomorrow.
Sorry for the confusion.
Here is his PM...
http://coloradok5.com/forums/private.php?do=showpm&pmid=823834
your next up Mike...wish I had about 10 of these.
But Howdiy has a set too!
not to trash you zimmer but the sway bar's are all the same k10-k30 
cowboypuller
Registered Member
no problem, just let me know
not to trash you zimmer but the sway bar's are all the same k10-k30
The one that came on my K5 I thought was smaller diameter than the one from the 60? Hmmmm. whatchooknowboutthat?
cowboypuller
Registered Member
from the research I have done there is 3 different dia of sway bars a 60 being the largest. I can get more info if you want. I am puting a 60 back under my 80 four door, someone took out the 60 and replaced with a 44 (go figure) trying to get it back to original.
cowboypuller
Registered Member
There are to two different sizes 1 1/16 and 1 1/4 i measured all my trucks 1/2 and 3/4 tons they were all 1 1/4 except my 86 surburban and it was 1 1/16 so i am assuming light surburbans and blazers have the smaller one. So i guess i don't need yours (Sorry). I'm glade you asked me or never would have measured and figured this out
