Did I screw up......again?

[45acpJr]

So I am gathering all my parts together for my 4" lift on Friday just making sure I have everything. And I noticed the springs on my front are 3" wide. When I measured them I measured at the spring eye which is 2.5". but the rest of the spring is 3" (I ordered 2.5" springs). Will this still work for me? Will it work when I put the Dana 60 in? I measured the flat spot on the dana 60 and it also measured around 3"

 

[metalneverdies]

Pretty sure your bushings should make it 3 inches. Measure to check though

 

[sweetk30]

stock front is just under 3" wide.

all aftermarket front lift springs for ours come out at 2.5" wide.

and good checking and asking before you have a goof.

 

[45acpJr]

Yeah after sitting and stewing for a few hours I figured it all out. I ordered all of my stuff from ORD at one time so I was going crazy trying to figure out which bushing went where. But we're good to go now, can't wait to get the lift on tomarrow