Drive shaft vibration/transfer case drop

[ryoken]

Hope they work for ya, arent those 4"?

that's what his should be with his 3.75 x 4.25 measurements.. not uncommon on a 3" kit to run 4" blocks.. the only thing I didn't check was spring width on those..

 

[prolinews]

Yep , the ones in it 4,1/4 on one end and 3, 3/4 on the short end I hope these fix it. I'm tempted to order a few shims just in case.

 

[jeff in co]

get steel shims that bolt to spring pack if you go that route. The aluminum ones get brittle and not as reliable.

http://www.amazon.com/gp/product/B006GJPS92?keywords=rubicon shim&qid=1448916458&ref_=sr_1_3&sr=8-3
This is general. Don't know the actual width but this gives you the idea.... I have them on my truck.

 

[prolinews]

Well I didn't quite get it perfect but now I'm 2* off but much better . The pinion is 2* higher than the tail shaft gonna slap some new u joints in it and ride.