Front driveshaft with NP208 & 6 inch lift

[thebluemax]

What type of driveshaft correction did you run with a NP208 and 6 inch lift on your truck? My driveshaft rubbed the crossmember so I put a spacer in but only 3 bolts lined up

Truck in question is an 84 k10

 

[big dan]

What kind of shape is your tranny mount in? If its worn out and squished it may help to replace it.

I also raised the t-case about a 1/2". Doing this you'll have to watch your rear driveshaft angle though as it will make the angle at the t-case steeper. It didnt hurt mine but every truck is different.

 

[thebluemax]

What kind of shape is your tranny mount in? If its worn out and squished it may help to replace it.

I also raised the t-case about a 1/2". Doing this you'lpl have to watch your rear driveshaft angle though as it will make the angle at the t-case steeper. It didnt hurt mine but every truck is different.

I replaced the transmission and motor mounts with poly. The transmission mount was trashed.

 

[gotblazers]

notch the crossmember? Im not sure if that would be considered bootyfab but i'd do it.

 

[thebluemax]

notch the crossmember? Im not sure if that would be considered bootyfab but i'd do it.

There is a member on here that pulled it off, but my fab skills are...how do you say...non existant. I could learn though.

 

[shaun89]

along with the x-member issue,I would grind out the cv of the driveshaft so it can flex/droop more,I can't find a thread on it though,can anyone help here?