Front driveshaft won’t fit

[TJ1978]

My front drive shaft. I have a 203 but I think 1350 u-joint to the front axle which is a 8lug 3/4 ton. I also run the flange connection to the 203 and not the ujoint connection, which I think is a 1310 joint if you use the ujoint and not the flange

Befor and after shot

 

[k51977blazer]

If you decide to go the flange route I have this.

View attachment 338967

I’m waiting on the junk yard to call me back to see if they still have it, how much would you want for it does it include the flange to how many inches is the driveshaft

 

[Capt Ron]

The flange is what I was showing you. If you get measurements I can see if I have the right length shaft you need.

 

[k51977blazer]

The flange is what I was showing you. If you get measurements I can see if I have the right length shaft you need.

Gotcha thanks The shaft is 27 inches

 

[Capt Ron]

Ok, I am not sure how you are measuring yours but this is what I have close by. The one on the far right should bolt up to your current yoke.

 

[k51977blazer]

Ok, I am not sure how you are measuring yours but this is what I have close by. The one on the far right should bolt up to your current yoke.

View attachment 339201

View attachment 339202

How much do you want for it?

 

[Capt Ron]

The older style is not readily available as it once was.
They have become pricey due this.

$75.00 plus shipping

 

[k51977blazer]

$75.00 plus shipping

I sent you a pm