Hey gang. I want to sell my 1 tons. These were previously installed in my 85 K5. Great axles, I just don't have a 4x4 any more and I don't want to have to deal with these things when I move. What they have:
Front: chevy D60, ATOR drive flanges, 35 spline stubs, 4.56 gears, Detroit, WFO high steer arms (the type that puts the tie rod above/behind the diff), rebuilt kingpins, ARP studs, GLO diff cover w/ reinforced center, extended kevlar DOT approved brake lines, 1410 yoke, and hella thick (WFO?) tie rod and drag link with low mile ends. Brakes are good, rotors are very low mile. 1.45 & 1.55". If you're going to run springs I have some beefy spring plates (DIY4x?) I will toss in too.
Rear: FF14b, 4.56 gears, Detroit, wheel spacers (to match width/track of the front), GLO diff cover, 1350 yoke. I actually bought this rear end brand new and only ran it for a short time, it prolly has 10,000 total miles on it, or less.
Not sure how much $ I have in these, but it's a lot. Asking for $2,000. No delivery or shipping, if you want them you'll have to come get them.

Front: chevy D60, ATOR drive flanges, 35 spline stubs, 4.56 gears, Detroit, WFO high steer arms (the type that puts the tie rod above/behind the diff), rebuilt kingpins, ARP studs, GLO diff cover w/ reinforced center, extended kevlar DOT approved brake lines, 1410 yoke, and hella thick (WFO?) tie rod and drag link with low mile ends. Brakes are good, rotors are very low mile. 1.45 & 1.55". If you're going to run springs I have some beefy spring plates (DIY4x?) I will toss in too.
Rear: FF14b, 4.56 gears, Detroit, wheel spacers (to match width/track of the front), GLO diff cover, 1350 yoke. I actually bought this rear end brand new and only ran it for a short time, it prolly has 10,000 total miles on it, or less.
Not sure how much $ I have in these, but it's a lot. Asking for $2,000. No delivery or shipping, if you want them you'll have to come get them.

Last edited:




