cegusman
3/4 ton status
Need quote for the 1.75 tie rod, left and right 7/8 threads with no ends. Lenght need for a dana 60 Shipped to 77084
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Heavy Duty Tie Rods and Drag links from PIMP Offroad
- Thread starter PJTPW
- Start date
These people never responded back to me recently so i started searching around and found my best deal with Trevor at WFO in Auburn Ca.
pvfjr
1/2 ton status
I gave up on them too. Went and made my own for me and a couple buddies. Averaged us $50 a rod for 1.5" 3/8 wall.
greyhoundjc
1/2 ton status
Need a quote for a dana 60 tie rod with 7/8-18 threads without the ends shipped to 30188. Also need to know what time of turnaround time to expect since the K5 is not driveable until I get a new tie rod. Thanks.
still make these HD tie-rods and draglinks?
morcav
Registered Member
muddybuddy said:
X2!!!!
Pimp Off-Road had a slight failure to launch problem due to high material and shipping cost in our area. we just could not compete. i would like thank everybody for there interest, and am sorry for any problems this may have caused.
Dirk
Pimp off-road
Dirk
Pimp off-road
jughead
Registered Member
Dirk does this mean my tube doors are not going to be made? I left a message at the number you gave and have not recieved a reply back yet.
