I've got a driveshaft that I ordered from HAD on 4/28/03. It has less than 100 miles on it. 1350 c/v shaft for 205 (you'll need to get the transfer case flange from HAD, if you don't already have one) 1410 axle end, had a 14 FF. I'll have to get measurements after work today, and I'll post a pic as well. It was on an 87 K5, 6" lift. .120 tube thickness. Paid $409 (I've still got receipt), selling for $250 plus shipping.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
High Angle Rear Driveshaft
- Thread starter TylerT
- Start date
yunit
1/2 ton status
Check shipping to 07650 for me, very interested, I need a spare.
shipping to 22039!!! very interested
yunit
1/2 ton status
Sold! Take paypal? Shoot me a PM with your paypal address if you do.
hope it works out for you
yunit
1/2 ton status
Paypal sent. 
Hopefully TylerT's first busniess transaction on CK5 goes smooth.
Hopefully TylerT's first busniess transaction on CK5 goes smooth.
yunit
1/2 ton status
Good looking out Jeff.
Well, hopefully there will not be any problems with the transaction.
Well, hopefully there will not be any problems with the transaction.
