Talking 69s mainly. Dana 60/9" front and rear axles. I have a question on the front setup. Has anyone ever seen or know anything about them? I'm wondering, how do you remove the third member without tearing the outers apart to pull the shafts? I can't see it being doable. And has anyone seen a 69 rear axle? Considering building one. Want to know what would be involved. Custom axleshafts of course, thinking dana 60 tubes and outer components with a 9" center section. 35 spline spool and then some axleshafts to go to it. Moser engineering does full float axleshafts for $295 a set.