Injectors won't spray (no power)

[tank52r]

1987 K5 Blazer TBI 350.

Was sitting for 7 years. This is what I have done so far

Emptied old gas
New fuel pump, filter
New pickup coil, and ignition module
New battery
Injecters cleaned and tested

I have a previous thread titled "TBI no fuel". Started a new thread because I've narrowed it down some.

It runs perfect when I put gas on top of the TBI. Im getting gas into the TBI, But injectors won't spray fuel

What gives power to the injectors. Any Ideas?

thanks,
-Frank

 

[bronc3buster842001]

Check the fuses for the ECM in the fuse box. Should have one that says ECM-B and ECM-1. The ECM-B is consant hot. The ECM-1 is ign power for the ECM. Hope this helps.

 

[Russell]

Pop the injectors out and look for corrosion / junk from dried up gas in the filter screens / passage ways.

 

[tank52r]

Check the fuses for the ECM in the fuse box. Should have one that says ECM-B and ECM-1. The ECM-B is consant hot. The ECM-1 is ign power for the ECM. Hope this helps.

That was it !!!! thank you so much I didnt know about that fuse changing like that.

Thanks again,
-Frank