Lets see your Duration

[beater_k20]

At .050:

Duration
Intake 204
Exhaust 214

Lift at cam
Intake 280
Exhaust 295

Lobe dep deg 112

Just barely lumpy at idle, great pull from way down low, excellent streetability.

very similar to my Summit 1102 cam in my 305. oddly, mine has no noticable change in idle quality. the tone is a bit different though. pulled into a derby and fired it up on the trailer, through my 1 1/2" 8 individual tube zoomies, it caused everyone within 100 yards to turn and look to see what it was.

 

[dyeager535]

If I would have known I would end up burning my own PROM's, I would have gone a bit more radical. Very strong down low, will idle any incline, top end starts to suck pretty quick.

Obviously a completely smooth idle. Sound based on the exhaust, nice and stock, the way I like it.

 

[adamforsythe]

I changed my cam idea once again.
http://store.summitracing.com/default.asp?target=partdetail.asp&part=EDL-7102&FROM=MG
Plus I will be adding a gear drive, 2.020 heads and couple other little goodies. I am still wondering what kind of carb I should run I have sent Edelbrock a e-mail about that. I am thinking about two 750CFM carbs J/K
By the way yes I know the Duration is pretty high for a k5 but there are no rocks in Maine just mud. Plus this truck won't see to much off-road life once it's gotthe new cam. This is my PLAY truck. If the cam seems to be to much I will just put in a smaller one.
Thanks
adam

 

[jeeptuff]

Well I got a few parts in from Jegs today.... The rest are coming in from Summit so I can get this engine put together and set on the dyno in a week or two prior to the install.

 

[Mike406Jimmy]

406ci small block. 280 duration, 214 @ .50, and .443