need help with hydro clutch master

[My Big Jimmy]

well a little back round, 72 jimmy big block sm465. im attempting to convert to hydro clutch. purchased a landcruiser slave, mount bracket and braided ss line from Advanced Adapters. i gota 94 chevy 1ton clutch mater cyl. from a local parts store. i dont know wat kinda fitting for the master. its not threaded. its kinda like a quick connect of some sort can somebody help please. thanks

 

[sweetk30]

yep pop in and seal line with a roll pin to hold in place. and its a nylon plastic line. factory type stuff as far as i know. i think you need a diffrent master. you might have the wrong one.

 

[My Big Jimmy]

damit i got this master cause it mounts flat to the fire wall. ive seen somebody in here use one i dont remember who and i can no longer find the thread. i dont rember any fitting talk anyways in it. thanks for ur input

 

[sweetk30]

if i recall try one for a 88-91 or 92. the 95ish and up i think is your style tthat went hose not hard line.

 

[bp71k5]

I used that master cylinder on mine.

Check out the parts list in my blog here (clutch fittings):
http://coloradok5.com/forums/blog.php?u=31238

You need to buy a couple fittings and hose from Advance Adaptors that work with that master cylinder. The fitting is part number #716130TJ from AA.

I can try and dig up a picture too.

 

[bp71k5]

Here's the link with a picture. I used their 12" stainless braided hose between the master and slave.

 

[My Big Jimmy]

thanks i saw some fittings on AA b they said they wer for jeeps. i havnt done any real homework and called them yet but hopin was a simple fitting i cant get at napa parts. its not did the 12" line come with that fitting, i got the 42" line, came witha fitting but not the size

 

[sweetk30]

88-up till that style are flat mount and i think nut style line. run to the store and have them pull one. worth a shot.

 

[My Big Jimmy]

this is the one ur talking about, it will still work even tho it saz for a jeeper? it looks like it may. am i gonna need a female to male fitting from that one to got to my line or is that the correct thread on the fitting from AA thanks for ur help

 

[bp71k5]

Yes, it's the same fitting I used on my chevy. The threads on it are the same as the female threads on the 12" line I got so no adaptor needed. I used the 12" line along with some solid brake line to get the shortest length possible. Trust me when I say that the line has to be routed so that the air doesn't get trapped inside while bleeding it.

Also, bleed the whole system off the truck as a unit. That'll save you hours of frustration.

 

[My Big Jimmy]

ok good thanks alot man, i just ordered the fitting from AA. i used a short pc. of brake line to adapt into the slave. iv read alittle about bleeding i think doing it out of the truck is the esiest way. thanks for ur help, ill post wen i get it all hooked up