New 203/205 doubler,triple stick and drive shafts

[rfda_454]

This is a New Never installed ORD Doubler, Rebuilt cases comes with Crossmember built to fit a gen 1 K5, Flange on the back.
Has a 27 Spline input with a th350 adapter on it
i also have the 32 Spline shaft and th400 adapter.
Brand New High Angle drive shafts,, 1350CV on the rear W/ Flange
1310CV on the Front. These are 100% new never installed
ORD Triple stick shifter also new Never installed.
They are a little dusty looking from being moved and stored.
All Together $1750
I Also Have a Th400 With short tail shaft for the 203 Trans is in Good Running Condition with torque converter for $400

 

[trav0302]

Would you sell just the doubler? And if so could you pm me your asking. Thanks

 

[nostomofo]

if you go the way of parting this, i'm seriously interested in the crossmember. pm me if you want to do this.

 

[63chevyll]

Hey I know Bryan is buying some parts from you.

I need to hook a 400 to a 203 for a doubler.

I'm interested in Your trans, because I believe the TH400 has a different output shaft for a 203.and if you have a 32 spline input for a 203 if you have any extra.

I need an adaptor also, if you have any extra

 

[rfda_454]

Pmed you back I have most of what your looking for

 

[mrdrinksalil]

i may be down for the rear driveshaft if I could get it with the tcase flange. shipped to 30542

 

[big pappa b]

I didn't get the flange so it may be availabe still

 

[rfda_454]

I'll check on that as soon as I can. May not be till Monday I'm headed to Denver do deliver a bunch of parts in the morning.

i may be down for the rear driveshaft if I could get it with the tcase flange. shipped to 30542

 

[gonefishin]

I may be interested in the tripple stick shifters

 

[rfda_454]

Shifters went with the cases

 

[big pappa b]

Mine...bwahaha

 

[big pappa b]

Did you sell the drivehafts? If not, what length are they?
\\Thanks

 

[rfda_454]

Haven't measured em yet. I'm out of town till next week but ill check and.get.back to you when I get back

 

[big pappa b]

Any luck on the driveshaft lengths yet?

 

[rfda_454]

Shifters went with the cases

Crap. I'll do it tomorrow after work, I got to swing by the.storage when anyway.

 

[big pappa b]

I haven' measured what length i need yet so I'm not sweating it,:-)

 

[rfda_454]

Front is 34" collapsed 39.5 extended.
Rear is 35" collapsed 41" extended.

 

[big pappa b]

Front won't work for sure. Is is 30 collapsed
Rear won't work right now either. With the 208 I'm at 30 on the rear too. If/when I go to the 205 it would be just about right

 

[rfda_454]

Can always shorten it. What is the setup I may have another set that will work its out of a k5 th400/208.

 

[big pappa b]

83 Jimmy..465/208 (LONG) 14 bolt moved back 1" w/zero rate...front D60 moved forward 1" w/custom springs