DEMON44
Low-Tech Redneck
I have to put my box back in service with my new job. I might want a hutch.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
New tool box on its way
- Thread starter 4X4HIGH
- Start date
Got word back today that the stainless top for the toolbox can still be used with the hutch. My co-worker will have his box and hutch tomorrow so i'll get to see if i really like the hutch or not. 
DEMON44
Low-Tech Redneck
Verdict ?
Well, i was out from work for 3 days (Drs order) and when I returned on friday we were too busy for me to really check out the hutch. I did find out however that the hutch is a hinge together deal and i'm not sure I like that. The rear panel is also a steel pegboard and not a flat steel back with pegboard inside like i had thought which doesn't make me feel happy about it either. I'll check it out better on monday. My guess though is that I could make a hutch for ALOT less than the $1190 they want for it.
DEMON44
Low-Tech Redneck
There's a guy here that built his own hutch. Nice for sure. Like $600 in materials.
DEMON44
Low-Tech Redneck
It's all aluminum plate I should add.
smalltruckbigcid
1/2 ton status
You and I have the same Mac box but I have the hutch and locker to go with mine. Mine just bolted to the stainless top. You drill 2 03 holes in it along the sides and 5 or 6 along the back and you're done.
Umm my box is the 84 inch and I think yours is a little shorter but I'd guess that it bolts on the same. Sorry I saw the size in the cart thread and forgot.
DEMON44
Low-Tech Redneck
But my stainless top isn't attached to my bottom box?
Pics please!
Pics please!
Guy buys a new toolbox and leaves out the most important info....sheesh.
Is it magnetic?
Have you mic'ed the sheet metal?
Is it magnetic?
Have you mic'ed the sheet metal?
