NP 205 gurus!!! Front output yoke.

[primerk5]

Dose someone make a front output yoke that is the flat version with corse splines(older T-case) I currently have a Corse spline yoke with the u-joint style yoke. I have a driveshaft with the flat CV that is the right length, The only driveshaft I have with the U-joint syle cv is too long and the CV is shot. And, You can't interchange the CV parts.


I went from a slip yoke np205 to a fixed yoke np205 and thought I could just change the front yoke and be on my way, WRONG!!!

Any suggestions?

Or, do I just have to come up with another drive shaft and have it shortend. Or have a new one made. (at the tune of around 200-250 bucks)

Also did k30 chevys ever come with a th350 trans Np205 case setup in the mid 70s? If this is the case they may have the right drive shaft I need. I need. Not that there is one of those anywhere around me.

Any help would be appreciated.

The distance from the center of the invisable ujoint at the T-case to the center of the invisable ujoint on my Dana 60 is around 25.5 inches.

 

[8_YOUR_H2]

The flange is not available in 10 spline, only the spicer yoke is available. Arizona driveline will make you one but they quoted me $180 to make a 1410 yoke in a 30 spline.

I have a 30 spline front output and flange Ill sell you for $50.

 

[primerk5]

The flange is not available in 10 spline, only the spicer yoke is available. Arizona driveline will make you one but they quoted me $180 to make a 1410 yoke in a 30 spline.

I have a 30 spline front output and flange Ill sell you for $50.

E-mail me

 

[BizeeB65]

I think I have one as well if that deal falls through.

 

[jms]

I think I have one as well if that deal falls through.

If primerk5 doesn't want yours (30-spline front output/flange), I'd be interested.

 

[primerk5]

I want one if someone would respond to my e-mail so I could get to paying for it.

 

[BizeeB65]

email sent.

 

[primerk5]

email sent.

Figures, one reply would come right after another. Who is who?

 

[4X4HIGH]

I went from a slip yoke np205 to a fixed yoke np205 and thought I could just change the front yoke and be on my way, WRONG!!!

From the sounds of it you have a slip yoke 205 that possibly has the correct flange you're looking for? Why not just swap the front outputs? It's a very easy job and would only take you maybe 10 minutes to do.

 

[primerk5]

I think thats what everyone is trying to sell me. Now, you make this sound awful easy. can it be done in the truck.

 

[Jimbo*]

Yes, it can be done in the truck.

 

[goldwing2000]

x2 on just doing the swap.

If you already have the parts, just get a new seal, a tube of RTV and call it a day.

Here's a page with step-by-step instructions:

http://okcnetworks.com/bronco/205/np1.htm

Start at #6.

Re-assembly starts at #56.

 

[primerk5]

x2 on just doing the swap.

If you already have the parts, just get a new seal, a tube of RTV and call it a day.

Here's a page with step-by-step instructions:

http://okcnetworks.com/bronco/205/np1.htm

Start at #6.

Re-assembly starts at #56.

Sounds like a winner. Thanks alot.